Powerdyne Bearing Press and Puller
The Powerdyne Press and Puller is a small tool for pulling and pressing wheel bearings.
To remove the bearing, the lever must be up and the pricking rod in a horizontal position. Then just put the wheel on the hook from the outside and pull the lever down. Repeat the same procedure for the other bearing.
If you want to press the bearing, just put the dowel rod in a horizontal position, put the bearing, the wheel, the limiter and the second bearing. After that, just put the rod in a horizontal position and push the lever downwards.
The tool can be attached to the table thanks to the attachment holes. Picking and pushing is only possible with wheels up to 84mm and 8mm spacers.